Efficient Networks Router family Command line interface Specifiche Scaricare il pdf (Pagina 257)

Efficient Networks

Router family

Command Line Interface Guide

Chapter 6: Connection Management

Efficient Networks

Page 6-43

If your service provider charges by the hour, you may want a PPPoE session to

timeout after a period of no traffic. However, if you do use a timeout, bringing up a

PPPoE session takes 2-3 seconds longer.

To permanently allocate a channel, use:

-> remote setminline 1 <remotename>

To set up a timeout, set the minline value to 0 and specify the timeout period in

seconds, as follows:

-> remote setminline 0 <remotename>

-> remote settimer <seconds> <remotename>

Sample PPPoE Configuration Script

The following script is an example showing commands for a PPPoE configuration.

The script assumes the following:

• The VPI/VCI for the connection is 0/35.

• The domain name for the service is DialUpPPP.net.

• The CHAP user name is JaneDoe and the CHAP password is Secret.

• Network Address Translation is desired for the PPPoE session.

• Only PPPoE traffic should pass through the bridge interface.

• Default IP route is used for the PPPoE session.

# Sample PPPoE Configuration Script

# ---------------------------------

# Enable IP routing for the Ethernet interface.

eth ip enable

# Define a remote router entry (named PPPoEbridge) to serve as

# the bridge for PPPoE traffic only.

remote add PPPoEbridge

# Set the link protocol (PPP, RFC 1483, RFC 1490).

remote setprotocol rfc1483mer PPPoEbridge

# Specify the VPI/VCI for ATM. (For Frame Relay, you would set the DLCI).

remote setpvc 0*35 PPPoEbridge

1 2 ... 252 253 254 255 256 257 258 259 260 261 262 ... 365 366

Nessun commento

Efficient Networks Router family Command line interface Specifiche Pagina 257